Technical
There are 3 common methods used to update the software in your ECU (Engine Control Unit)
The end result is the same only the actual method varies.
This is possibly the most commonly used terminology, and refers to the process of removing (sometimes de-soldering) one or more memory chips from the ECU and either reprogramming or replacing them with new chips.
Involves removing the ECU from the vehicle in the same way as you would for chip tuning, however instead of actually de-soldering a chip from the ECU, the required software files are accessed via the reading points
Click Here for More POWER
Chip Tuning
BDM
Remapping
Involves reading and writing files to and from the ECU via the vehicles OBD (Diagnostic Port) This method avoids the need to remove the ECU from the vehicle.
Remapping via the OBD is not technically possible on some vehicles.
The results achieved are relative to the quality of the software programing rather than the method used to read and write the file to and from the ECU
The quality of the software file produced for your vehicle is the most important factor relating to the performance of your engine.
Software Quality is Crucial - Read More...
Which Method Is Best
Click Here for More MPG
CR
Chiptuning
TM
Remapping & Chip Tuning Specialists for Glasgow & the South West of Scotland
VW Audi Seat Skoda
If you drive a VAG Group Car see our credit crunch beating deal, well below the prices offered by any of our professional competitors Click Here for more information.
FORD Car Offer
If you drive a FORD Car see our credit crunch beating deal, well below the prices offered by any of our professional competitors Click Here for more information.
